If your device collects data, transmits wirelessly, or includes electronic control systems, it likely falls under FCC and CE scope. Here are the kinds of products we commonly handle:

• Asset Trackers
  GPS-enabled devices using LoRa, NB-IoT, or LTE to report location and environmental conditions—requiring RF and EMC testing.

   

• Temperature & Humidity Sensors
  Widely used in cold chain, agriculture, and warehousing—especially when data is transmitted via Bluetooth or WiFi.

   

• Industrial Vibration Sensors
  Installed on motors or heavy machinery to detect early signs of failure; many include wireless transmission for predictive maintenance.

   

• Smart Flow Meters
  Monitor liquids or gases and send data via Zigbee, WiFi, or cellular networks—falling under multiple directives.

   

• Tank Level Monitors
  Used in logistics and industrial process control, these often combine analog sensors with wireless communication modules.

   

• RFID Gateways & Readers
  Devices that manage and scan RFID tags need RF certification and EMC testing due to continuous scanning and wireless communication.

   

• Environmental Monitoring Systems
  Air quality, pressure, or gas detection systems that use integrated wireless modules for remote reporting.
  

For the U.S., FCC certification applies to any electronic device emitting radio frequency energy. Industrial devices typically fall under:

• FCC Part 15 for unlicensed transmitters (WiFi, Bluetooth, Zigbee)

• Additional parts for cellular, GPS, and other specialized protocols

• EMC testing for interference caused by sensors, processors, and converters

For Europe, CE certification is required across multiple directives:

• The Radio Equipment Directive (RED) for wireless communication

• The EMC Directive for electromagnetic emissions and immunity

• The Low Voltage Directive (LVD) for mains- or battery-powered systems

• Potential ATEX requirements for devices used in explosive environments

Keep in mind that if your device uses multiple wireless technologies (e.g., GPS + Bluetooth), each one must be tested and certified. CE certification is based on self-declaration, but it requires a full technical file and compliance with applicable harmonized standards. FCC certification requires accredited lab testing and, for many RF devices, formal equipment authorization.

You’ll typically need:

• RF testing across all wireless protocols

• EMC testing for emissions and susceptibility

• Safety evaluations (especially for high-voltage or harsh environments)

• Technical documentation (manuals, wiring diagrams, test reports)

• Proper labeling (FCC ID, CE mark, frequency or safety notices)

• Retesting if changes are made to wireless modules, antennas, or firmware